Categories: Washer Repair
Kenmore washer repair Miami

Kenmore washer repair Miami

Are you worried that it’s time for your Kenmore washer to get professionally repaired?  Are you having problems with it like it’s not draining the way it should, or maybe it’s draining by way of leaking water all over the floor?  If this sounds like what’s going on in your home with your washing machine, it may be time for a drain pump replacement.

The good news is that for some people, following the information we’ll provide below will mean it’s a Do-It-Yourself repair, and you won’t need to call in a service technician.  For everyone else who maybe isn’t so “handy”… we’ve got good news for you too!  You’re on the website of Miami’s Best Appliance Repair, and we’ll be more than happy to come out to you to get things fixed up in no time.

And just so you know, when we perform a service call (usually the same day you call us), and we go on to do the repair for you, there is no service fee.  That’s more good news!

So let’s take a look at the process of replacing your drain pump on your Kenmore washer (actually, this is the same process for any  top loading direct drive Whirlpool, Kenmore, Sears, Roper, KitchenAid, Estate, Maytag, or Inglis washing machine).  If you decide to give this a try yourself and find out you’ve bitten off a bit more than you can chew, don’t hesitate to call us at (305) 748-4223 and we’ll send someone out right away.

Kenmore Washing Machine Drain Pump Replacement

As with any repair, be sure you’ve unplugged the appliance before beginning. Your first step is to move the control panel out of the way.  To do this, remove the screws found at either end.  On some models these screws may be located in the rear panel or they may be covered by plastic end caps.  Pull the end cap off from the top to access the screw. Remove both screws and rotate the panel up.

Some models use clips instead of screws to secure the control panel.  Insert a putty knife between the control panel and the cabinet to release the clips. Unplug the wire connector and snap out the spring clips using a flat head screw driver.  Tilt the cabinet toward you, slide it forward and remove.  Now unsnap the retainer clips holding the old drain pump on and wiggle the pump off of the motor shaft.

Using pliers, release the clamps to remove the two hoses from the drain pump. Be prepared for water to spill out of the hoses.

Set the old pump aside.  You’re now ready to install the new drain pump.

Slide the hoses over the ports of the new pump and secure them with the clamps.  Align the motor shaft with the pump and slide the pump on.  Reinstall both pump clips. Now reinstall the cabinet.

The front edge of the cabinet slides underneath the base frame.  Use your foot to push it into position.  Align the two notches in each side of the cabinet with the tabs on each side of the base frame.  Now ease the cabinet to match up with the rear panel.

Reinstall the spring clips, reattach the wire connector, rotate the control panel down and lock the clips into place or reinstall the two screws if applicable to your model. Replace the end caps by aligning the tab with the slot at the bottom and snapping the cap into position.

You are now ready to plug the appliance back in to make sure it’s functioning properly now that you’ve successfully completed your Kenmore washer repair yourself.

About the Author

Open Google Maps Widget settings to configure the Google Maps API key. The map can't work without it. This is a Google's rule that all sites must follow.

Best Appliance Repair Miami

175 SW 7th Street Miami, FL 33131 (305) 748-4223

Top